0. LEGISLATIVE PROVISIONS
0.1. NAME OF STANDARD
0.1.1. This Standard is the Vehicle Standard (Australian Design Rule 51/00 –
Filament Lamps) 2006.
0.1.2. This Standard may also be cited as Australian Design Rule 51/00 —
Filament Lamps.
0.2. COMMENCEMENT
0.2.1. This Standard commences on the day after it is registered.
0.3. REPEAL
0.3.1. This Standard repeals each vehicle standard with the name Australian
Design Rule 51/00 — Filament Lamps that is:
(a) made under section 7 of the Motor Vehicle Standards Act 1989;
and
(b) in force at the commencement of this Standard.
0.3.2. This Standard also repeals each instrument made under section 7 of the
Motor Vehicle Standards Act 1989 that creates a vehicle standard with
the name Australian Design Rule 51/00 — Filament Lamps, if there are
no other vehicle standards created by that instrument, or amendments to
vehicle standards made by that instrument, that are still in force at the
commencement of this Standard.
1. SCOPE
This Australian Design Rule (ADR) prescribes the dimensional and
photometric requirements for filament lamps which ensure
interchangeability and correct functioning when installed in a lamp unit.
2. APPLICABILITY AND IMPLEMENTATION
2.1. The circumstances under which lamps are mandatory, optional, or
prohibited are set out in either ADRs 13/.., 19/… or 67/….
3. DEFINITIONS
3.1. Refer to paragraph 2.1 of Appendix A.
4. REQUIREMENTS
4.1. Devices complying with the technical requirements of Appendix A, part
5 Exemptions and Alternative Procedures and part 6 Supplementary
General Requirements shall be accepted as complying with this vehicle
standard.
Federal
