A. LEGISLATIVE PROVISIONS
A.1. NAME OF STANDARD
A.1.1. This Standard is the Vehicle Standard (Australian Design Rule 57/00 –
Special Requirements for L-Group Vehicles) 2006.
A.1.2. This Standard may also be cited as Australian Design Rule 57/00 — Special
Requirements for L-Group Vehicles.
A.2. COMMENCEMENT
A.2.1. This Standard commences on the day after it is registered.
A.3. REPEAL
A.3.1. This Standard repeals each vehicle standard with the name Australian
Design Rule 57/00 — Special Requirements for L-Group Vehicles that is:
(a) made under section 7 of the Motor Vehicle Standards Act 1989; and
(b) in force at the commencement of this Standard.
A.3.2. This Standard also repeals each instrument made under section 7 of the
Motor Vehicle Standards Act 1989 that creates a vehicle standard with the
name Australian Design Rule 57/00 — Special Requirements for L-Group
Vehicles, if there are no other vehicle standards created by that instrument,
or amendments to vehicle standards made by that instrument, that are still
in force at the commencement of this Standard.
B. SCOPE
B.1. The function of this national standard is to specify special requirements for
the construction of L-Group vehicles.
B.2. They must also comply with all requirements for L-group vehicles as set
out in individual ADRs.
C. APPLICABILITY AND IMPLEMENTATION
C.1. Applicability Summary
C.1.1. This national standard applies to the design and construction of vehicle as
set out in the table below.
Federal Register
